ガス精製装置

Products

Click-On In-Line Super Clean Big Trap Filter Kits

  • Largest-capacity traps availablerun longer without replacing.
  • “Quick connect” fittings with spring-loaded check valves allow filter replacement in seconds without tools or contamination.
  • Maximum operating pressure of 11 bar (160 psig).
  • High-purity output ensures 99.9999% pure gas (maximum flow of 8 L/min).
  • Triple gas trap is ideal for purifying carrier gas.
  • Helium-specific triple gas trap is made for GC-MSready to use within 15 minutes of installation.
  • Hydrocarbon trap removes hydrocarbon contamination from carrier gas to help eliminate ghost peaks.

製品情報を見る

Dynamic Duo (Restek Leak Detector and ProFLOW 6000 Flowmeter)

Protect your instrument and improve data quality with this powerful pair from Restek. Checking for leaks and verifying flows before you start running help you avoid costly problems later.

製品情報を見る

Restek ProFLOW 6000 Electronic Flowmeter

Flowmeters that can measure flammable gases are becoming mandatory due to the increased use of hydrogen in chromatography. With its Ex rating, the Restek ProFLOW 6000 meter is designed specifically with explosive and flammable gases in mind.

製品情報を見る

Restek リークディテクタ

わずかなリークでも、カラムのダメージにつながります。Restekのリークディテクタでカラムの劣化を未然に防ぎましょう。

  • リークの状態を音でお知らせします
  • 完全充電後12時間稼働できます
  • 幅広いガスを検知できます

製品情報を見る

Click-On In-Line Super Clean Indicator

  • Oxygen: green to grey
  • Moisture: beige to clear

製品情報を見る

Helium-Specific Click-On In-Line Super Clean Gas Connector Kits

Helium-specific Click-On in-line Super Clean gas kits are designed specifically for purification of helium in GC-MS systems.

製品情報を見る

Restek Click-On In-Line Super Clean Gas Traps and Connector Kits

  • High-purity output ensures 99.9999% pure gas.
  • Click-On fittings for easy, leak-tight cartridge changes; brass or stainless steel, 1/4" or 1/8".
  • Triple gas trap is ideal for purifying carrier gasit contains oxygen, moisture, and hydrocarbon scrubbers in one cartridge.
  • Fuel gas trap is ideal for purifying flame ionization detector (FID) fuel gases, removing both moisture and hydrocarbons.
  • Helium-specific triple gas trap is ideal for GC-MSit contains oxygen, moisture, and hydrocarbon scrubbers in one cartridge.

製品情報を見る

Helium-Specific Super Clean Filter and Kit

  • Specifically designed for purification of helium in GC-MS systems.
  • Traps are packed and conditioned using helium.
  • Uses standard single-position baseplate.

製品情報を見る

Electronic Maintenance Indicators for Gas Filters

  • Audiovisual warning system ensures maintenance is done on time.
  • Progressively displays gas filter status, preventing unplanned downtime for maintenance.
  • Can be custom configured to your replacement/maintenance schedule.

製品情報を見る

Restek Super Clean Ultra-High Capacity Oxygen Filter

Restek Super Clean ultra-high capacity oxygen filter cartridges feature easy-to-read indicators.

The indicator code is shown on every trap so there is no confusion determining when a trap needs to be replaced.

製品情報を見る

Restek Super Clean Ultra-High Capacity Moisture Filter

Restek Super Clean ultra-high capacity moisture filter cartridges feature easy-to-read indicators.

The indicator code is shown on every trap so there is no confusion determining when a trap needs to be replaced.

製品情報を見る

Accessories

for In-Line Super Clean Gas Traps and Connectors

Click-On In-Line Super Clean Double Connector

Connects any Click-On trap to a Click-On indicator.

製品情報を見る

Click-On In-Line Super Clean Connectors

Click-On connectors allow you to change traps quickly, without introducing oxygen into your system.

製品情報を見る

Wall Mounting Bracket

Baseplates can be mounted by using screws and the mounting holes on the baseplate, or by using this optional wall mounting bracket.

製品情報を見る

Restek Super Clean Gas Trapping System for LC-MS

A Super Clean quick-change cartridge system efficiently removes hydrocarbons from nitrogen!

  • Designed for easy, hassle-free cartridge changes.
  • Up to 20 L of hydrocarbon-free nitrogen per minute.
  • Filters connected in parallel to handle high flows for LC-MS.

製品情報を見る

Gas Pressure Gauge Kit

  • Use an in-line pressure gauge to indicate when a thermal gas purifier getter tube should be replaced.
  • Includes 1/8" tee and 0100 psi (0-689k Pa) gauge.

製品情報を見る

1/8-Inch to 1/4-Inch Tube End Reducer

To adapt 1/8" Super Clean baseplate fittings to 1/4" tubing, use 1/8" to 1/4" tube end reducers.

製品情報を見る

Replacement O-Rings for Cartridge Baseplates

Pack includes 10 large O-rings and 10 small O-rings.

製品情報を見る

Restek Super Clean Gas Filter Kits

  • High-purity output ensures 99.9999% pure gas (at max. flow of 2 L/min).
  • Designed for easy, hassle-free cartridge changes.
  • Glass inside to prevent diffusion; polycarbonate housing outside for safety.

製品情報を見る

Restek Filter Baseplates

  • End fittings available in brass or stainless steel.
  • Baseplates fit all stand alone Super Clean gas filters offered.

製品情報を見る

Hydrocarbon S-Trap

  • Removes hydrocarbons and other contaminants.
  • Reduces organics to 0.1 ppm (assuming 100 ppm input).
  • Each individually activated to ensure maximum efficiency.
  • Fits in GC oven for easy thermal recharging.
  • Maximum operating pressure: 60 psi (414 kPa).

製品情報を見る

ECD Vent Trap

  • Reduces the release of hazardous materials from the ECD vent into the lab.
  • Includes connecting lines and mounting kit.

製品情報を見る

VICI Mat/Sen Gas-Specific Purifier Modules

  • Replace separate oxygen, moisture, and hydrocarbon traps with one multiple-bed purifier, specific for purifying helium, hydrogen, nitrogen, or air.
  • Reduce gas impurities from ppm to low ppb levels.
  • Decrease baseline noise and increase GC-MS sensitivity.
  • Pre-purged with the specified gas to shorten downtime.

製品情報を見る

High-Capacity Split Vent Trap

  • Reduces the release of hazardous materials from the capillary split vent into the lab.
  • Includes connecting lines and mounting kit.

製品情報を見る

Refillable Hydrocarbon Trap

  • Removes trace impurities from carrier gas.
  • Reduces organics to 0.1 ppm (assuming 100 ppm input).
  • 60 µm frit prevents gas contamination by purifier particles.
  • Good for purge-and-trap systems.
  • Refillable and rechargeable.
  • Maximum operating pressure: 125 psig (862 kPa).
  • Maximum flow: 5 L/min.

製品情報を見る

Capillary-Grade Hydrocarbon Trap

  • Packed with an extremely high surface area, baked coconut shell–based activated carbon.
  • Purged with ultra-high-purity helium; ready to use with any carrier gas including hydrogen.
  • Reduces organics to 0.1 ppm (assuming 100 ppm input).
  • Maximum operating pressure: 250 psi (1,724 kPa).

製品情報を見る

Indicating Moisture Trap

  • Reduces water to less than 10 ppb; indicator changes from yellowish-green to blue at 5% relative humidity.
  • Prepurged for fast stabilization.
  • Reduces noise from high-sensitivity detectors.
  • Heavy-walled glass body prevents oxygen and water infusion.
  • 10 µm frit prevents microparticulate damage to needle valves and flow controllers.
  • Maximum operating pressure: 100 psi (689 kPa).

製品情報を見る

High-Capacity Moisture Trap

  • Purged with ultra-high-purity helium; ready to use with any carrier gas including hydrogen.
  • Reduces water to less than 15 ppb.
  • Maximum operating pressure: 250 psi (1,724 kPa).
  • Maximum flow: 1.25 L/min.

製品情報を見る

Molecular Sieve S-Trap

  • Traps water vapor; increases column and oxygen trap lifetime.
  • Reduces baseline noise from sensitive detectors such as ECDs and mass spectrometers.
  • Activated and ready to use.
  • Reduces water to less than 1 ppm.
  • Maximum flow: 1 L/min.

製品情報を見る

High-Capacity Oxygen Trap

  • Removes up to 135 ml of oxygen or 2 g of water.
  • Long lifetypically purifies more than 480 cu ft of inert gas.
  • Reduces oxygen to 15 ppb.
  • Maximum operating pressure: 250 psi (1,724 kPa).
  • Flow: 3 L/min @ 32 psi (221 kPa).

製品情報を見る

Replacement Chemical Traps and Parts

Agilent GC用

  • Easy to install.
  • Attach to same fittings as original manufacturer's equipment.

製品情報を見る

Indicating Oxygen Trap

  • Indicator changes from light green to grey as oxygen is trapped.
  • Heavy-walled glass body, protected by polycarbonate sleeve, prevents oxygen and water infusion.
  • Prepurged for fast stabilization.
  • 100 psi (689 kPa) maximum operating pressure.
  • Reduces oxygen to 0.1 ppm.
  • 10 µm frits at inlet and outlet.
  • Optimal flow rate: < 150 mL/min.

製品情報を見る

Restek Gas Management System

  • Removes moisture, hydrocarbons, and oxygen from carrier gas, extending column lifetime.
  • Produces high-purity carrier gas for most applications.
  • Includes one each: moisture, hydrocarbon, and indicating oxygen trap.
  • Replacing traps is safe and easy.
  • Maximum flow: 150 cc/min for optimal performance.

製品情報を見る

Particle Drop-In Filter

for use with Super-Clean Gas Filter for LC-MS

Replacement Gas Filters

for Restek Super Clean Gas Filter Kits

  • High-purity output ensures 99.9999% pure gas (at max. flow of 2 L/min).
  • Designed for easy, hassle-free cartridge changes.
  • Glass inside to prevent diffusion; polycarbonate housing outside for safety.
  • All traps measure 10 5/8" x 1 3/4" (27 x 4.4 cm).

製品情報を見る

Soft-Side Storage Case

for Restek ProFLOW 6000 Electronic Flowmeter or Leak Detector

Optional soft-side storage case is ideal for storing your flowmeter or leak detector in smaller spaces, such as your tool box.

製品情報を見る