delim
delim
delim
Underground Storage Tank Monitoring (UST)

Underground Storage Tank Monitoring (UST)

Products

定性的なリテンションタイム インデックス 標準試薬 27化合物

・ 幅広い範囲のリテンションインデックスシステムを充当。
・ 認証標準試薬(CRM)で検証された安定性と正確さ。
・ 定性分析で組成が確認されており、それぞれのCRMのロットについて証明書を添付。

製品情報を見る

Diesel:Biodiesel (80:20) Blend Standard

The biodiesel component is methyl soyate.

製品情報を見る

Mineral Spirits

There are four general types of mineral spirits, classified according to boiling point range (BPR):
  • Type I (Stoddard solvent), BPR 149–182 °C
  • Type II (high flash point), BPR 177–196 °C
  • Type III (odorless), BPR 149–196 °C
  • Type IV (low dry point), BPR 149–174 °C

    This standard is manufactured using the Type 1 mineral spirit.

    Note: Cat.#s 31260 and 31261 are produced with CAS# 64475-85-0, a Type 1 Mineral Spirit containing the proper ratio of n-alkanes (higher proportion) and isoparaffins/cycloalkanes (lower proportion). Lots produced prior to March 2017 contained CAS# 8030-30-6, a C10-C13 isoparaffins odorless Mineral Spirit with >98% isoparaffins (branched alkanes/aromatics) and minimal n-alkanes.

製品情報を見る

MA VPH Matrix Spike Mix with Surrogate Rev. 1.1 (July 2004) (16 components)

  • For current Massachusetts VPH method: surrogate included.
  • Matrix spike mix at 50µg/mL, per updated method.

製品情報を見る

MA VPH Standard with Surrogate Rev. 1.1 (July 2004) (16 components)

  • Standard for current Massachusetts VPH method: surrogate included.
  • More analyses per ampulstandard with surrogate is 10,000µg/mL.

製品情報を見る

CA WIP VOA Standard (11 components)

For monitoring samples suspected of gasoline contamination, Los Angeles County requires laboratories to calibrate and report these compounds.

製品情報を見る

Certified Aromatics in Gasoline (16 components)

  • Confirm unleaded gasoline TPH, BTEX, and aromatics in a single analysis.
  • Certificate of Analysis includes concentration of TPH, and certified concentrations of BTEX and individual aromatics.
  • Complete data pack available.

製品情報を見る

Stoddard Solvent Standard

We offer this certified reference material for those who need to calibrate Stoddard solvent separately. This standard is dissolved in methanol for analysis by either direct injection or purge and trap.

製品情報を見る

Fuel Oil Degradation Mix (4 components)

Subsurface degradation of fuel oil spills can be estimated by examining the ratios of C17/pristane and C18/phytane.1 To assist in identifying these four compounds from the complex fuel oil analysis, we offer a product that contains these compounds for retention time determination.

製品情報を見る

Diesel Fuel #2 Standard

Prepared from a single-source (one-refinery) product.

製品情報を見る

Kerosene Standard

Prepared from a single-source (one-refinery) product.

製品情報を見る

Unleaded Gasoline Standard

Prepared from a single-source (one-refinery) product.

製品情報を見る

Hydraulic Oil Standard

  • For total petroleum hydrocarbon pattern recognition of hydraulic oil.
  • High concentration50,000 µg/mL in methylene chloride.

製品情報を見る

Creosote Oil Standard

Creosote oil is a coal tar derived distillate.

  • For total petroleum hydrocarbon pattern recognition of creosote oil.
  • High concentration50,000 µg/mL in methylene chloride.

製品情報を見る

Aviation Gas Standard

100-octane, low-lead fuel used in piston-type aircraft.

製品情報を見る

Fuel Oil #6 Standard

A high-viscosity residual type of heavy fuel oil requiring preheating to 104–127 °C. This material is also known as residual fuel oil (RFO) or Bunker C.

製品情報を見る

Fuel Oil #4 Standard

Fuel oil #4 is typically used in limited applications in which the fuel cannot be preheated prior to burning. The fuel is a blend of distillate (fuel oil #2) and residual (fuel oil #6).

製品情報を見る

Used Motor Oil Composite Standard

  • Prepared from an equal-volume blend from five gasoline-powered vehicles (belonging to Restek employees). After blending, a precisely weighed amount of the composite is added to a volumetric flask to produce the standard.
  • Motor oil standards may exhibit lot-to-lot variation.
  • See the Documentation tab for chromatograms on certificates of recently produced lots and inquire about availability.

製品情報を見る

Motor Oil Composite Standard

  • Prepared from an equal-volume blend of 5W30, 10W30, 10W40, and 20W50 motor oils. After blending, a precisely weighed amount of the composite is added to a volumetric flask to produce the standard.
  • Motor oil standards may exhibit lot-to-lot variation.
  • See the Documentation tab for chromatograms on certificates of recently produced lots and inquire about availability.

製品情報を見る

Kerosene Composite Standard

  • Kerosene composite standards are comprised of three separate sources blended in equal portions.
  • Kerosene standards may exhibit lot-to-lot variation.
  • See the Documentation tab for chromatograms on certificates of recently produced lots and inquire about availability.

製品情報を見る

Diesel Fuel #2 Composite Standard

  • Diesel Fuel composite standards are comprised of three separate sources blended in equal portions.
  • Diesel Fuel standards may exhibit lot-to-lot variation.
  • See the Documentation tab for chromatograms on certificates of recently produced lots and inquire about availability.

製品情報を見る

Unleaded Gasoline Composite Standard

  • Unleaded gasoline composite standards are comprised of three separate sources each of 87, 89, and 93 octane blended in equal portions.
  • Gasoline standards may exhibit lot-to-lot variation.
  • See the Documentation tab for chromatograms on certificates of recently produced lots and inquire about availability.

    NOTE: BTEX content of catalog numbers 30081, 30205, and 30206 is not measured. Certified BTEX gasoline standards are available as catalog numbers 30237 and 30485.

製品情報を見る

TNRCC 1005 Retention Time Markers Mix (4 components)

  • Easily determine the retention time window for each boiling point range.
  • Prepared in n-pentane according to EPA requirements.

製品情報を見る

Massachusetts APH Mix (26 components)

Our high-quality air monitoring gas calibration standards are provided by Spectra/Linde and Airgas (formerly Scott/Air Liquide gas)meeting lab requirements for two separate sources of calibration standards.

Note: Actual cylinder pressure may vary due to loss from quality testing procedure.

To view compatible regulators, select your standard below and see Restek Recommends.

製品情報を見る

BTEX Gas Mix (6 components)

Our high-quality air monitoring gas calibration standards are provided by Spectra/Linde and Airgas (formerly Scott/Air Liquide gas)meeting lab requirements for two separate sources of calibration standards.

Note: Actual cylinder pressure may vary due to loss from quality testing procedure.

To view compatible regulators, select your standard below and see Restek Recommends.

製品情報を見る